7
8
After Sales Support
TEL:
1300 663 907
After Sales Support
TEL:
1300 663 907
Cable setup
1. Connect the left and right speaker wires to the speaker jacks on the side of the
Micro Hi Fi. (24)
2. Plug in the AM antenna loop to the right side of the Micro Hi Fi. (22)
3. Unravel the FM antenna to full length.(21)
4. Position the AM and FM antennas away from the Micro Hi Fi to reduce the chance
of interference.
5. Peel off the protective layer of film over the screen and front panel of the Micro Hi Fi.
6. Connect the power cord to the DC power socket (25) and the power outlet,
and then switch the power outlet on.
Setting the time
2 SEC
A. In standby mode, press and hold the CLK-ADJ.
B. Scroll between 12 HR or 24 HR format, then press CLK-ADJ to confirm.
C. Scroll to set the hour, then press CLK-ADJ to confirm.
D. Scroll to set the minutes, then press CLK-ADJ to confirm.
Note:
The time will be reset completely if the power is disconnected from the mains
power supply.
Note:
The clock set mode will reset if there is 3 seconds of inactivity.
VI. Using the radio
Manual tuning
1. Press function button (6) to select “tuner” mode.
2. Press “random” button (18) to select desired band (AM or FM).
3. Tune to the required station by pressing the tune “+” or “−” button (19, 13).
Auto tuning
1. Press function button (6) to select “tuner” mode.
2. Press “random” button (18) to select desired band (AM or FM).
3. Press and hold the tune “+” or “−” button (19, 13) for 1-2 seconds and then release.
4. The unit will start seeking automatically and stop when a radio station is reached.
5. Repeat step 3 & 4 until the desired radio station has been reached.
6. Adjust volume up/down button (8, 4) to the desired volume level.
Preset stations
You can store up to 20 radio stations in the memory (10 AM and 10 FM).
1. Press function button (6) to select “tuner” mode.
2. Turn to the desired radio station. (See manual tuning instructions, above)
3. Press “mem/clk-adj ” button (12) to activate the memory programming function.
“Mem” indicator is show on LCD display.
4. Press up “pre-up” or “pre-dn” button (15, 16) to select the desired memory number.
5. Press “mem/clk-adj” button (12) again to confirm the memory number.
6. Repeat step 2 to 5 to store other stations. You can overwrite a preset station by
storing another frequency in its place.
7. Play any of your preset stations by pressing the up “pre-up” button (15) or “pre-dn”
button (16) when in radio playback mode. This will cycle through your 10 presets.
Note:
The preset stations will be reset completely if the power is disconnected from the
mains power supply.
