9
6
After Sales Support
TEL:
1300 663 907
After Sales Support
TEL:
1300 663 907
V. Setup
Prepare your Micro Hi Fi for desktop use
1. Ensure the stand is securely fastened to the speakers and the Micro Hi Fi.
2. Place the speakers and Micro Hi Fi upright on the desk.
Preparing your Micro Hi Fi for wall mounted use
1. Use a screwdriver to remove the stand from the speakers and the Micro Hi Fi.
2. Use the wall mounting template to make anchor hole marks on the wall. Use a spirit
level (not included) to ensure the template is level when marking the anchor holes.
3. Use a drill to make ¼” drill bit to make holes where your anchor marks are.
4. Insert the plastic anchors supplied with the Micro Hi Fi, making sure that they are
flush with the wall.
5. Insert the screw into the plastic anchor, and tighten until the screw head is about
4mm away from the wall.
6. Hang the Micro Hi Fi on the screws, as indicated in the Diagram B.
Diagram B
Hints for best reception
•
The Micro Hi Fi has a built in FM wire antenna (21). This wire should be unravelled
and fully extended for the best FM reception.
•
If FM stereo signal is being received, the stereo indicator
will be displayed
on the LCD screen. When a mono signal is received, *ST* will not be displayed.
•
In areas of poor reception, you may wish to switch to FM mono mode. Press the
“st/mo” button (15) to switch between stereo mode and mono mode.
•
The Micro Hi Fi comes with an AM loop antenna. Connect the AM antenna to the
AM socket (22) on the side of the Micro Hi Fi. If AM reception is poor, rotate and
reposition the loop antenna to improve the reception.
•
Position both AM and FM antenna as far from the Micro Hi Fi as possible to reduce
the chance of electronic interference.
•
AM reception may be improved by placing the antenna as high as possible, such as
on top of a bookshelf or entertainment unit.
•
Radio reception may vary according to the signal strength in your local area.
VII. Using the CD player
Getting Started
1. Press function button (6) to select CD mode.
2. Press “open/close” button (17) to open the CD compartment.
3. Place a CD with the printed side facing towards you inside the compartment.
4. Close the CD compartment by pressing the “open/close” button (17) again.
5. The LCD screen will display the total number of tracks & total playing time.
6. Use the following controls to play the CD.
- Play and Pause (15)
- Stop playback (11)
- Skip forward track (13)
- Skip backward track (19)
Repeat play mode
Press the “repeat” button (16) during playback to select the repeat or random function.
Pressing the “repeat” button several times allows you to cycle through the following
functions::
(flashing) – Repeat a single track
– Repeat entire CD
(no icon) – No repeat
Diagram A
