Bauer MSXH, Operating Manual, Page: 28 / 52

Operating Manual for BAUER Submersible Mixer/ Version I-2013 28

The red light for probe 1 or 2 is on:
(Note: tripping device RDA 02 has turned the motor off)

Turn the switch for mode of operation to 0

Press reset key for about 3 seconds

Red light goes out
– put turn switch to the required position after 15 seconds

The motor is starting up again.

The red light
„continues lightening“
:
Check if

probes are really submerged

the mixer is not enough submerged

there is a loss of fluid inside the tank

Adjustment of the potentiometer for transmitting the medium not correct
Remedy the cause of the malfunction
Lower the mixer until the probes are below medium surface.
Add medium.
Tune the operating threshold of the potentiometer with the medium
Repeat start-up operation :

The red light of the leak detector lights up:
(Note: tripping device RDA 01 has turned the motor off)

Turn the switch for mode of operation to 0

Put main switch
into position „
0
“, wait for 5 seconds, put it back to position „
1
” (power supply on)
(This operation comes up to a reset function of the tripping device).
If the light continues lightening check the mixer for leaks.
Adjust sensitivity
6.3.7 Safety instructions
Always shut down the power supply before working on the starter.
02