Page 13
For technical questions, please call 1-888-866-5797.
Item 58215
SA
FE
TY
OP
ERA
TI
O
N
MAINT
ENANC
E
SE
TUP
For Wet Sawing - Connecting Water System
TO PREVENT SERIOUS INJURY AND ELECTRIC SHOCK:
Do not allow water to enter the motor.
Check all water connections for leaks. If leaks are
found, do not use Saw for wet sawing until leaks
are fixed. Do not exceed water pressure of 70 PSI
.
1. Attach wet vacuum to Dust Port.
2. Connect Water Tube:
a. Connect to Water Connector 1 for water
output on both sides of Wheel.
b. Connect to Water Connector 2 for
water output on left side of Wheel.
3. Close Water Valve.
4. Connect garden hose to Tube's
Water Hose Connector.
5. Open garden hose valve slightly.
6. Open Tube's Water Valve. Water should
flow smoothly over the wheel. Adjust
garden hose valve as necessary.
Water Valve
Open
Closed
Garden Hose
Connector
Water
Connector 1
Water
Connector 2
For Dry Sawing - Dust Extraction Setup
Attach dust collection system to Dust Port.
Work Piece and Work Area Set Up
1. Work piece selection: This tool is designed
to cut masonry, stone, concrete, reinforced
concrete, and similar materials. Choose the
proper wheel for the material being cut.
2. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
3. Route the power cord along a safe route
to reach the work area without creating a
tripping hazard or exposing the power cord
to possible damage. The power cord must
reach the work area with enough extra length
to allow free movement while working.
4. Verify that there are no utility lines or
hardware in or near the workpiece.
This is especially critical for plunge cuts.
