BaudTec RE300B1, User Manual

Page: 30 / 96

11n Repeater User’s Manual
30
WPS Pairing between 11n Repeater and Wireless
xDSL/Cable Modem
This section describes how to do WPS Pairing between 11n
Repeater and Wireless xDSL/Cable.
The diagram below illustrates the hardware connections. The
layout of the ports on your device may vary from the layout
shown. Refer to the steps that follow for specific instructions.
Step 1. Press WPS button on Wireless xDSL/Cable Modem.
Step 2. Press WPS button on 11n Repeater for 3 seconds
and release WPS button. Now the WPS LED is blinking and
the 11n Repeater is donig WPS Pairing with Wireless
xDSL/Cable Modem.
Make sure to press the button within 120 seconds (2
minutes) after pressing the Wireless xDSL/Cable Modem's
WPS button.
Step 3. Once the 11n Repeater finished doing WPS Pairing
with Wireless xDSL/Cable Modem, the Wifi Signal Strength
LED is ON. The status of Wifi signal strength LED varies
depending on the Wifi signal strength between 11n
Repeater and Wireless xDSL/Cable Modem.
Step 4. Check if the Wifi Signal Strength LED of 11n
Repeater is ON, the 11n Repeater is connected and suitable
for Internet Connections.
Step 5. Check if the Wifi Signal Strength is OFF, the 11n
Repeater isn’t connected and suitable for Internet
Connections. Please repeat steps of WPS Pairing or follow
next step to have it connected and suitable for Internet
Connections.