19
Battipav srl
GB
MACHINE DESCRIPTION
The VIP site cutter is a machine intended specifically
for cutting ceramics, single-fired items, terracotta,
and marble (Max thickness 20 mm), up to a thickness
of 40 mm.
The machine uses a wet diamond tipped tool cutting
system and is intended for personnel specialized in
the construction sector.
The operator works in front of the narrow side of
the machine, within reach of the operating controls,
and positions the material to be cut on the moving
worktop. He/she starts the machine and moves the
cutting head to bring the tool into contact with the
material.
TECHNICAL DATA
Voltage:
230V 50Hz~
Power absorbed:
1000 W
Admissible working conditions:
INTERMITTENT S3 SERVICE
50%
under load running
50%
repose
Rotation speed:
2800 min-1
Condenser:
14 µF
Thermal circuit breaker:
170°C
IP Degree:
54
RECOMMENDED USE:
CUTTING TOOL
DIAMOND BLADE WET CUTTING
CONTINUOUS CROWN:
ceramic, single-fired ceramic, cotto and marble (max.
thickness 20 mm.)
THE TOOL / MATERIAL TO BE CUT MATCHES ARE
PureLy iNdicatiVe.
aLwayS
FoLLow
the
iNteNded
uSe
iNdicatioNS ProVided By the cuttiNG tooL
MaNuFacturer BeFore aNy aPPLicatioN.
Water recirculation pump: S0 230V 50/60Hz
INSTALLATION
TRANSPORT
The VIP machine is easy to carry by using the
specially provided side handles.
Before carrying the machine make sure that:
• the motor carriage is locked in place with the
two cutting adjustment knobs on the slide rail;
• the motor carriage is completely lowered and
locked with the locking lever;
• the machine is in the 45° (jolly) position and
the inclination adjustment knobs are properly
tightened;
• the tube-holder rod is out of its housing.
3
• the feet are closed with the leg locking pin.
POSITIONING
Place the machine on a stabile surface.
To place the machine in working position, proceed as
follows:
CAUTION
MAkE SURE THAT THE SLIDING CARRIAGE IS
Locked By MeaNS oF the carriaGe LockiNG
STOPPER.
THE MOTOR SLIDE IS LOCkED IN PLACE WITH
THE TWO CUTTING ADjUSTMENT kNOBS ON
the SLide raiL;
Remove the machine from the packaging with the
aid of the side carrying handles.
To place the machine in working position, proceed as
follows:
4
1) Remove the machine from the packaging with
the aid of the side carrying handles.
To place the machine in working position,
proceed as follows:
2) Lift the leg making it slide inside the relevant
slot.
5
3) Repeat the operation for the front part
6
4) Insert the tube-holder rod in its seat
