Battipav 701200, Operating Instructions Manual, Page: 23 / 26

34
GB Battipav srl
CUTTING fOR THICKNESS Of UP TO:
150 mm
Ø 250 mm blade
200 mm Ø 300 mm blade
By adjusting the position of the cutting head using the
locking lever, it is possible to cut materials of a height
of up to 150 or 200 mm in two passages.
26
By making use of the graded index located on
the side of the motor head, lower the head until
reaching the desired measurement.
• By means of the cutting square, arrange the
piece to be cut on the working table at the
desired measurement.
27
• Start the machine and carry out the first cut.
• Turn over the piece 180°, and repeat the cut.
CUTTING A SURfACE AT 45°
CAUTION
Before positioning the motor head, make sure that:
• the machine is off;
• the cutting tool is not moving;
45° CUTTING fOR THICKNESS Of UP TO:
45 mm
Ø 250 mm blade
65 mm Ø 300 mm blade
28 Referring to the graded scale located on the
machine upright, move the motor head to the 45°
position and tighten the knobs.
29
• With the locking lever, lower the cutting head
until placing the blade some millimetres below
the table level;
30
• Arrange the piece to be cut on the working
table at the desired measurement;
30
• Start the machine and wait until cutting
blade cooling water comes out, adjusting the
necessary amount by means of the water on-off
valve located on the blade guard, and cut.
LASER MARKER
CAUTION
Standard on DYNAMIC 760S and 1200S.
CLASS IIIA LASER INSTRUMENT
By means of the laser marker accessory, the cutting
operations can be accelerated.
As a matter of fact, the special laser system is able
to indicate the tool cutting line on the working table.
CAUTION
THE LASER MARKER STARTS WORKING ONCE THE
MACHINE IS CONNECTED TO THE POWER SUPPLY.
31
CUTTING WITH LASER MARKER
• connect the machine to the power supply;
• position the piece to be cut making sure that the
line indicated by the laser marker matches the
reference on the material to be cut;
• perform the cutting operation as indicated in the
paragraph: “CUTTING ON THE TABLE”.
CAUTION
DO NOT MODIfY THE MARKER POSITION BY
TURNING THE BEAM TOWARDS THE OPERATOR’S
EYES.
DO NOT GAZE AT THE BEAM WITH THE NAKED EYE
OR LOOK DIRECTLY WITH OPTICAL INSTRUMENTS.
MARKER ADJUSTMENT
In case the marker is not aligned with the cutting line,
its correct alignment can be adjusted.
In order to correctly position the marker, proceed as
follows:
32
• loosen the three bulb locking screws so that it
can be moved;
• position a reference properly on the tool
cutting line.
32
• insert the 5 mm Allen wrench provided in the
hexagonal slot located on the bulb;
• Using the Allen wrench, turn the bulb until
aligning the mark with the tool cutting line.