Battipav 701200, Operating Instructions Manual, Page: 20 / 26

31
GB Battipav srl
INSTALLATION
TRANSPORT
The DYNAMIC machine can be easily moved by
using the transport handles.
Before carrying the machine make sure that:
3
• the sliding carriage is in the locked position;
• the motor carriage is locked by means of the
locking knob located on the slide rail;
3
• the legs are in transport position;tor head is
locked by means of the locking lever;
CAUTION
4
TO MOVE THE MACHINE, USE A fOUR-ARM
TIE ROD, BY MAKING USE Of THE HOOKS IN
THE TRANSPORT HANDLES.
4
To move the machine, use a four-arm tie rod
with the capacity to lift 200 kg or at least 20%
more than the machine weight, by making use
of the hooks in the transport handles.
HANDLING
By using the “transport wheels” accessory, the
machine can be moved with the aid of a second
person.
CAUTION
IN ORDER NOT TO COMPROMISE THE MACHINE
STABILITY, KEEP STRICTLY TO THE fOLLOWING
PROCEDURES.
WITH THE AID Of A SECOND PERSON, HOLD THE
MACHINE DURING THE WHEEL KIT INSTALLATION
OPERATIONS.
When the machine is in working position:
a) loosen the leg locking pin on the opposite side
of the control unit;
5
b) lift the leg and put it in the wheel support;
c) lock the leg with the relative locking pin;
5
d) tighten the wheel support setscrew;
e) repeat the operation for the other wheel.
CAUTION
IN ORDER TO fACILITATE THE DYNAMIC MACHINE
MOVEMENT IN THE YARD, WE RECOMMEND
LOWERING IT UNTIL THE LOWERED POSITION.
a) loosen the leg locking pins on the front side,
one at a time, holding the machine from the
transport handles;
6
b) lower the machine front side, making the legs
slide inside the supports until the leg middle
hole matches the hole of the supports;
c) lock the legs by means of the relevant leg
locking pins;
d) repeat the operations indicated in points (a),
(b), (c) for the rear side.
7
LOCK THE CARRIAGE AND THE MOTOR
HEAD BEfORE MOVING THE MACHINE.
POSITIONING
Place the machine on a stabile surface.
To place the machine in working position, proceed as
follows:
CAUTION
MAKE SURE THAT:
8
1) THE BALANCING MOTOR HEAD IS LOCKED
BY MEANS Of THE LOCKING LEVER
2) THE CARRIAGE IS BLOCKED IN MOTOR
HEAD WITH THE LOCKING KNOB AND
THE PAD SAfETY IN THE TRANSPORT
POSITION
9
a) put the leg locking pins in release position ;
10
b) by means of the transport handles, lift one
side of the machine until the working position.
CAUTION
10
fOR CORRECT MACHINE POSITIONING, MAKE
SURE THAT THE LEG UPPER HOLE MATCHES
THE LEG COUPLING HOLE, BEfORE fINALLY
LOCKING IT.
10 c) lock the legs one at a time;