bathstore Comfort Cushion, User Instructions

Page: 8 / 20

8
• Remove any non slip mats from the area
where the suction cups will be positioned.
• Ensure the bottom of the bath is clean
and smooth, with no oil or bath cleaner
residues that will prevent the suction feet
from sticking.
WARNING:
The suction cups
may not adhere to the surface in baths
that have been re-enamelled or that have
rippled or textured surfaces. Do not use if
the suction cups do not adhere to the bath.
• Pass the air hose through the loop in the
corner of the backrest (
A
fig.2), on the
side that you propose getting into and out
of the bath. The air inlet valve (
B
) can be
rotated, allowing the hose to be led to the
appropriate corner.
Fitting the Comfort Cushion in
the bath
• Fold the backrest over onto the seat as
indicated in fig. 3. Lightly place the deflated
Comfort Cushion in the middle of the
empty bath with the ‘handle’ (
C
) aligned
with the centre of the bath.
• Hold the ‘handle’ and pull the Comfort
Cushion towards the slope of the bath
until there is a gap of approximately 25mm
between the bath slope and ‘handle’
(
C
figs. 3 & 4).
• Firmly press all four suction cups down
and check that they are securely stuck to
the bath. Wet them to help them stick if
necessary.
• Fold the backrest out so that it rests on the
slope of the bath.
A
B
25mm approx.
C
C
2
3
4
Before fitting the Comfort Cushion
in the bath