17
English
4.
Remove the accessories for the dust
extraction and then take the fitted tool
out of the product.
5.
Clean the product.
8. Cleaning and care
WARNING!
Risk of injury!
Switch the product off, disconnect it from
the mains and let the product cool off
before carrying out any inspection, mainte-
nance or cleaning work!
1.
Always keep the product clean, dry and
free from oil or grease. Remove any
dust after every use and before storing.
2.
Regular and proper cleaning aids
ensure safe use and prolongs the ser-
vice life of the product.
3.
Check the product for worn-out and
defective parts before every use. Do not
use it if you notice any defect or worn-
out parts.
4.
Make sure that no liquids penetrate the
inside of the product.
5.
Clean the product with a dry cloth. Use
a brush for areas that are difficult to
access.
6.
Use a cloth and brush to remove any
dirt and dust from the vents in
particular.
7.
Scrub off any stubborn dust with air
pressure (max. 3 bars).
WARNING!
Risk of damage!
Never use chemical, alkaline, abrasive or
other aggressive cleaning or disinfection
products to clean the product, as these may
damage the surfaces.
Maintenance
– Before and after each use, check the
product and accessories (e.g. fitted
tools) for wear and damage.
– If necessary, replace them with new
ones as described in this user manual.
Observe the technical requirements in
the process (see “Technical data”).
Replacing the carbon brushes
The carbon brushes may only be replaced
by a specialist workshop or qualified
specialist.
Replacing the mains cord
If the mains cord of this product is dam-
aged, it must be replaced by the manufac-
turer, its After Sales Support department or
a similarly qualified person in order to pre-
vent hazards.
Replacing the batteries
If the laser stops working, the battery must
be replaced.
1.
Loosen the screw
(21b)
and remove the
battery compartment lid
(21a)
from the
battery compartment
(21)
.
2.
Remove the button cell
(21c)
(see
Fig. 9
).
3.
Now insert the new button cell. Make
sure the polarity is correct.
4.
Attach the battery compartment lid to
the battery compartment again and
tighten the screw.
5.
Never dispose of old or empty batteries
in your household garbage, instead
always take them to special battery or
special garbage collection points (see
chapter “Disposal”).
Repair
There are no parts that can be repaired by
the user inside this product. Contact the
After Sales Support line to check and repair
the product.
Ordering spare parts
WARNING!
Have your product repaired by the
After Sales Support line or a quali-
fied electrician using only identical replace-
ment parts. This will ensure that the safety
of the product is maintained.
Always have the manufacturer of the prod-
uct or its After Sales Support replace the
plug or the mains cord. This will ensure that
the safety of the product is maintained.
7063051-Thor-Compact-Ma-1804-30.indb 17
04-06-18 11:55
