23
1.
Install the two end rafters, grooves up. The end with the horizontal hole is at the top.
2.
At the top, the bolts already holding the RidgeRrafter Clips should be loose enough to slip the
top of the end rafter in between. Use a 5/16 x 1 3/4” bolt and nut to secure each.
3.
Use a 5/16 x 3” bolt and nut to attach the bottom of the end rafter to the Medium Rafter Clip at
the center of each of the end rails. The bolt also goes through the hole at the center of the lacing
rail. The lacing rails and clips are free to move around slightly.
4.
Tighten the rest of the bolts that fasten the Ridge Rafter Clips to the ridge rails.
DIAGONAL RAFTER ASSEMBLY
END RAFTER ASSEMBLY
39’
33’
30’
26’
1.
Install the diagonal rafters, grooves up, as located in the diagram above. Use 5/16 x 3” bolts.
The rafters are identified by length, hole pattern and ID number on pages 6 & 7.
22
24
24
22
21
22
22
22
36
36
22
24
21
24
24
END
RAFTER
END
RAIL
LACING
RAIL
MEDIUM
RAFTER
CLIP
5/16 x 3"
hex head
?
SEE PAGE 5
5/16 x 1 3/4"
hex head
22
?
SEE PAGE 5
CORNER
RAFTER
END
RAFTER
RIDGE
RAFTER
CLIP
SIDE
RAFTER
SIDE
RAFTER
SIDE
RAFTER
SIDE
RAFTER
CORNER
RAFTER
CORNER
RAFTER
DIAGONAL
RAFTER
DIAGONAL
RAFTER
DIAGONAL
RAFTER
DIAGONAL
RAFTER
21
21
21
21
21
21
21
21
FOR
WARD
