GF Health Products, Inc. - www.grahamfield.com Zenith Series Service Manual 999-0831-190C DEC. 2013
10
ZENITH SERIES
10
1. HEADBOARD INSTALLATION
• The headboard comes with four pre-installed
inserts - consider this the inside of the board.
• Position 2 mounting tubes on the outside of
the headboard with “L” facing inward.
• Align the top hole of the mounting tubes with
the top holes in the headboard.
• Insert a 40mm hex drive bolt through each of
the top holes and bottom holes and screw into
each insert. Tighten with the Hex Allen wrench
included in the kit.
• Slide the “L” portions of the Mounting tubes
into the hollow ends of the main frame rails,
at the head deck end.
•
FOR 80” BEDS:
Slide the mounting tubes in
until the first tube hole lines up with the first
rail hole. See sample below.
•
FOR 76” BEDS:
Slide the mounting tubes in
until the first tube hole lines up with the second
rail hole. See sample below.
2. FOOTBOARD INSTALLATION
• The footboard comes with four pre-installed
inserts - consider this the outside of the board.
• Position 2 mounting tubes on the inside of the
footboard with “L” facing outward.
• Align the top hole of the mounting tubes with
the top holes in the footboard.
• Insert a 40mm hex drive bolt through each of
the top holes and bottom holes and screw into
each insert. Tighten with the Hex Allen wrench
included in the kit.
• Slide the “L” portions of the Mounting tubes
into the hollow ends of the main frame rails,
at the foot deck end.
•
FOR 80” BEDS:
Slide the mounting tubes in
until the first tube hole lines up with the second
rail hole. See sample below.
•
FOR 76” BEDS:
Slide the mounting tubes in
until the first tube hole lines up with the third
rail hole. See sample below.
HEADBOARD
FOOTBOARD
Inserts
on inside
40mm
Bolts
CENTER
OF BED
CENTER
OF BED
80” hole position
(1st hole in)
80” hole position
(2nd hole in)
76” hole position
(2nd hole in)
76” hole position
(3rd hole in)
Inserts
on outside
40mm
Bolts
NOTE: The first hole at the foot end is reserved for
attaching the Optional 4” pan extension.
HEAD- AND FOOTBOARD ASSEMBLY
1st hole
IMPORTANT:
76” OR 80”HEADBOARD &
FOOTBOARD POSITIONS
MUST MATCH RETAINER
& WALLSAVER POSITIONS.
PLEASE SEE PAGES 11-12.
1st hole
