HEADBOARD
FOOTBOARD
Inserts
on inside
CENTER
OF BED
CENTER
OF BED
Inserts
on outside
40mm
Bolts
40mm
Bolts
IMPORTANT:
76" OR 80" HEADBOARD AND FOOTBOARD POSITIONS
MUST MATCH RETAINER AND WALLSAVER POSITIONS.
SEE BED SERVICE MANUAL.
5
/
16
X 1.625" Detent Pin
with Lanyard 100-7931-011
Quantity = four (two per board)
first mounting
tube hole for both
76" and 80" positions
first mounting
tube hole for both
76" and 80" positions
80" hole position
(first bottom hole
from end)
76" hole position
(second bottom hole
from end)
Detent Pin (attached
to frame with Lanyard)
76" hole position
(second bottom hole
from end)
80" hole position
(first bottom hole
from end)
Detent Pin (attached
to frame with Lanyard)
HEADBOARD AND FOOTBOARD POSITIONS USING THE
QUICK-RELEASE DETENT PINS
HEADBOARD INSTALLATION
1. The headboard has four pre-installed inserts on the
inside surface.
2. Position two mounting tubes on the outside of the
headboard with “L” facing inward toward center
of bed. Align the mounting tube top holes with the
headboard top holes.
3. Insert socket head cap screws from Panel Mounting
Kit through top holes into headboard.
4. Insert a second set of socket head cap screws
through third-from-top tube holes into headboard.
Hand tighten only.
5. From both sides, insert the lanyard-attached detent
pins through the frame holes as shown, ensuring the
detent pin balls extend completely through rails.
6. At the head end, slide the mounting tube “L” portions
into the main frame rail hollow ends.
a. FOR 80" BED LENGTH: Slide the mounting tubes
in until the first tube holes align with the first rail
holes as shown below.
b. FOR 76" BED LENGTH: Slide the mounting tubes
in until the first tube holes align with the second
rail holes as shown below.
7. Tighten the four screws with the hex key included in
the kit.
FOOTBOARD INSTALLATION
1. The footboard has four pre-installed inserts on the
outside surface.
2. Position two mounting tubes on the inside of the
footboard with “L” facing inward toward center of bed.
Align the mounting tube top holes with the footboard
top holes.
3. Insert socket head cap screws from Panel Mounting
Kit through top holes into footboard.
4. Insert a second set of socket head cap screws
through fourth-from-top tube holes into footboard.
Hand tighten only.
5. From both sides, insert the lanyard-attached detent
pins through the frame holes as shown, ensuring the
detent pin balls extend completely through rails.
6. At the foot end, slide the mounting tube “L” portions
into the main frame rail hollow ends.
a. FOR 80” BED LENGTH: Slide the mounting tubes
in until the first tube holes align with the second
rail holes as shown below.
b. FOR 76” BED LENGTH: Slide the mounting tubes
in until the first tube holes align with the third rail
holes as shown below.
7. Tighten the four screws with the hex key included in
the kit.
GF Health Products, Inc. - www.grahamfield.com
Slide-W-I-D-E Expandable/Retractable Sleep Deck Supplement 999-0881-190G
ZENITH SERIES
5
