Base aire UVC3, Installation & Operation Manual

Page: 8 / 12

6
Transportation And Storage
If you store or transport the device incorrectly, the device may be damaged.
Pay attention to information about transportation and storage.
Transportation
Before transporting the equipment, please observe the following regulations:
Do not drag the device with the power cord during transportation to prevent the device from moving
and vibrating to avoid damage to the electrode.
Hold the power plug while unplugging the power cord from the power outlet.
Turn off the device
If the device was in use before, please wait until the timing period is over before transferring the
device.
After
transporting the equipment, please observe the following regulations:
Install the equipment in an upright position after transportation.
Storage
When the device is not in use, please observe the following storage conditions:
When the equipment is not in use, always disconnect the power supply.
Store the Baseaire UVC3 Pro ozone generator in a dry place to avoid the influence of bad weather,
and cover it to protect it from invasive dust.
Clean Electrode
The electrode can be cleaned in the built-in state. Before cleaning the electrode, check for cracks. Do
not use damaged parts!
Ensure that the equipment is protected from splash water.
Do not install this machine near flammable substances or gases.
Use a dry (lint-free) or damp cloth to clean the components. After cleaning, make sure that no fibers
(fluff) remain on the electrode.
Do not use the device before the electrodes are completely dry.
The following requirements must be met when installing the Baseaire UVC3 Pro ozone generator:
Only use the Baseaire UVC3 Pro ozone generator according to the parameters provided in the
"Technical Data" chapter.
Make sure to place the device on a dry and vibration-free surface.
Make sure that there are no obstructions at the air inlet and outlet.
If possible, place the device in the center of the room to ensure optimal air circulation.