Basalte Deseo Cresnet, Manual

Page: 12 / 17

Deseo Cresnet
Manual
12 / 17 v0.6 © 2020 basalte
Analog input:
<
External_Humidity >
Receives the relative humidity from an external sensor. If enabled in
the
‘ Basalte Deseo Configuration ’ module the humidity can be
displayed on the start screen of the Deseo.
This value is ignored if the internal sensor is used.
Analog output:
<
Internal_Humidity >
Reports the relative humidity of the built-in humidity sensor in whole
numbers.
The humidity report type can be set using the ‘Basalte Deseo
Configuration’ module.
Analog inputs:
< Heat_Setpoint_FB >
< Cool_Setpoint_FB >
The current heat and cool setpoint temperature to display on the
display. Reported in tenths of a degree.
Remark : The Deseo displays only one setpoint. This makes it not
recommended to use dual setpoints in combination with auto mode!
Analog input:
<
Single_Setpoint_FB
>
The current setpoint temperature to display on the display.
Analog outputs:
< Heat_Setpoint >
< Cool_Setpoint >
Reports the heating and cooling setpoint after changing the setpoint
by pressing up or down button on the Deseo. Reported in tenths of a
degree.
Analog output:
< Single_Setpoint >
Reports the single setpoint after changing the setpoint by pressing up
or down button on the Deseo. Reported in tenths of a degree.
Analog inputs:
< Min_Heat_Setpoint >
< Max_Heat_Setpoint >
< Min_Cool_Setpoint >
< Max_Cool_Setpoint >
Sets the minimum and maximum setpoints allowed to display and
report by the Deseo. Reported in tenths of a degree.
Default analog values are as follows:
Heat setpoint: 380 to 890 (38° to 89°F); or 30 to 320 (3° to 32°C).
Cool setpoint: 590 to 990 (59° to 99°F); or 150 to 370 (15° to 37°C).
In case single setpoint is used: 59 to 89 °F or 15 to 32 °C.
Serial input:
< Clock$ >
This input can be connected to the output of a Clock Driver symbol to
make the time of day available on the display.
Serial input:
< Message$ >
Sends text string to display on the Deseo.
The string will be visible on the display for a time specified in the
‘ Basalte Deseo Configuration ’ module .
Serial input:
< Multitouch_Short_Message$ >
Sends text label for display when the Multitouch Short Press is
activated.