10
Manuale d’installazione e d’uso
EN
Read the instructions contained in this handbook carefully as they give important advice concerning safety of instal
-
lation, use and maintenance. Keep this handbook for any further consultation by the various operators. After having
removed the packing, make sure the equipment is intact. In case of doubt, do not use the equipment and contact
professionally qualified staff. Before connecting the equipment, make sure that the rating corresponds to that of
electricity mains. The equipment must only be used by staff trained in use of the same. Before carrying out cleaning
and maintenance, disconnect the equipment from the electricity supply system. Switch the equipment off in the
case of a fault or malfunctioning. For any repairs only contact an authorised technical service centre and request
the use of original spare parts. Failure to observe the above may jeopardise safety of the equipment. Connection,
installation of the system and appliances, ventilation and fumes extraction must be carried out according to the ma
-
nufacturer’s instructions, by professionally specialised staff. The current regulations of the fire brigade should also
be observed. The electrical safety of this equipment is only ensured when it is correctly connected to an effective
earthing system as laid down by current electrical safety regulations. This fundamental safety requirement has to
be checked and, in case of doubt, an accurate check on the system by professionally qualified staff requested. The
manufacturer cannot be considered liable for any damage caused by failure to earth the system. This equipment
must only be used for the purpose for which it was specifically designed. Do not wash the equipment with direct,
high pressure jets of water. Do not obstruct the openings or vents for extraction or release of heat. So as to avoid the
risk of rust or chemical attack in general, the stainless steel surfaces have to be kept properly clean. Clean the parts
in stainless steel daily with warm, soapy water, then rinse thoroughly and dry carefully. On no account should the
stainless steel be cleaned with steel wool pads, brushes or scrapers in standard steel, in that they could deposit fer
-
rous particles which, by oxidising, cause rust spots. Stainless steel wool can, if necessary, be used in the direction of
the satin finish. Should the equipment not be used for long periods, wipe all the steel surfaces vigorously with a cloth
moistened with Vaseline oil in order to apply a protective layer; also air the rooms periodically. The manufacturer
of the appliance declines every responsability for possible mistake contained in this booklet imputable to printing or
transcription errors. It also reserves the right to bring changes to the product if retains useful or necessary without
jeopardizing the essential characteristics. The manufacturing company declines any and every responsability if the
rules brought in this manual are not strictly observed. The manufacturer of the appliance declines all responsibility
for damage caused by faulty installation, tampering with the appliance, improper use, poor maintenance, failure to
observe local regulations and unskilled use.
1. INSTALLATION
1.1 Important notice
Before the installation, take away the equipment from its packing. Some pieces are protected with a plastic film
that must be taken away with care. If some residuals of glue remains on the surfaces take care to remove it acting
with right substances, like gasoline, and never with abrasive substances. Fit up the feet on the equipment. The
equipment must be leveled (the feets are adjustable for height). Make sure of the backing plate solidity. The master
switch or the socket must be near the equipment and within easy reach. The installation of an exauste hood over
the equipment is advisable. Take care to observe all fire-fighting law prescriptions. If the appliance is placed against
a wall, this must be able to withstand temperature of 80°C and if it is inlammable, heat isulation must be installed.
1.2 Positioning
