Barton 96053C, Owner'S Manual And Safety Instructions

Page: 9 / 15

OPERATION
2
NOTE: Do not attempt to operate this appliance until you have read and thoroughly understand all safety
information in this manual and all assembly is complete and leak tests are routinely performed.
BEFORE LIGHTING THE HEATER
1. Heater should be thoroughly inspected before each use by a qualified technician, When re-lighting the
heater, always wait at least 5 minutes.
2. Inspect the hose assembly for evidence of excessive abrasion, cuts or wear. Suspected areas should be
leak tested. If the hose leaks it must be replaced prior to operation. Use only replacement hoses specified
by the manufacturer.
LIGHTING THE HEATER:
NOTE:
For initial start or after any cylinder change,
hold the knob in for two minutes to purge air from
the gas lines before proceeding.
1. Turn the control knob to the OFF position.
2. Fully open the LPG tank valve.
3. Push in and turn the control knob to the HI
location
4. Keep the control knob depressed and push the
RED igniter button simultaneously. Push several
times to ignite the main burner. Repeat until the
burner ignites and keep the control knob fully
depressed for an additional 30 seconds after the
burner ignites, then release the knob.
5. To increase the flame, turn the control knob
clockwise towards HI. To decrease the flame turn
the control knob counter-clockwise towards LO
position. 6. To
turn the appliance off, depress the control knob
and turn clockwise to the OFF position.
7. Wait at least 5 minuted for attempting to re-light
the heater. 8. Turn the LPG tank valve to OFF or
closed. If you experience any ignition problems, see
the TROUBLESHOOTING section of this manual.
CAUTION:
Avoid inhaling fumes emitted from
the heater’s first use. Both smoke and odor from
burning of oils used in the manufacturing will
appear. Both smoke and odor will dissipate after
approximately 30 minutes, The heater should not
product thick black smoke.