background image

SAFETY INFORMATION

Read all safety warnings and instructions. Failure to follow the warnings and instructions may result in 

injury and/or property damage. Save all warnings and instructions for future reference. 
The warning and safety instructions in this manual are not meant to cover all possible conditions and 

situations that may occur. Common sense, caution and care must be exercised when operating or 

cleaning tools and equipment. Always contact your dealer, distributor, service agent or manufacturer 

about problems or conditions you do not understand before operating the product. 

1

WARNING: 

This heater is not equipped with a device to control the room temperature. Do not use this 

heater in small rooms when they are occupied by persons not capable of leaving the room on their 

own, unless constant supervision is provided.

Failure to comply with the precautions and the instructions provided with this heat lamp can result in 

death, serious injury and property damage or loss from hazards of fire, explosion and burns.
During operation, this product can be a source of ignition. Keep the heater area clear and free from

combustible materials, gasoline, solvents, paint thinner, cleaning solvents and other flammable vapors

and liquids.

Minimum heater clearances from combustibles is three feet from the sides and two feet from the top 

of the heater.

NEVER

 operate this device with the protected heating element opening blocked. Keep this opening 

free of lint, hair, etc. Never operate on or near a soft surface such as a pillow, blanket, or bed where 

this air opening may be blocked.

NEVER

 store propane near high heat, open flames, pilot lights, direct sunlight, other ignition sources 

or where temperatures exceed 120 degrees F.

Propane vapors are heavier than air and can accumulate in low places. If you smell gas, leave the area

immediately.

NEVER

 install or remove propane cylinder while the heater is lit, near flame, pilot lights, other ignition

sources or while the heater is hot to the touch.

Store the propane cylinder outdoors in a well ventilated space out of reach of children. 

NEVER

 store 

the propane cylinder in an enclosed area. If storing indoors, disconnect the cylinder.

This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. 

NEVER

 

locate heater where it may fall into a bathtub or other water container. To protect against electrical 

hazards,

 DO NOT

 immerse in water or other liquids.

Check with your local fire safety authority if you have questions about heater use. Other standards 

govern the use of fuel gases and heat producing products for specific uses. If no local codes exist, 

follow the National Fuel Gas Code, ANSI Z223.1.

Summary of Contents for 96053C
















Reviews: