Depending on the surface and the application, the installation can be performed with the
mounting profile
(Art. 4050004xor 4050008x), the
bracket set
(Art. 40500045), with thermal
conductive double-sided
adhesive tape
(Art. 30033009) or with
construction adhesive
(Art.
63500030).
The use of the mounting profile (Art. 4050004x) is permitted only in combination with the
technical vaseline (Art. 63500022)!
When using the
bracket set
it is recommended to install a bracket approx. every 25 cm to
ensure a secure holding of the AQUALUC C:URVE mini.
The AQUALUC C:URVE mini must not be fitted over joints that may expand and contract due to
ambient conditions. In particular, the thermal expansion of materials must be taken into ac-
count. It is therefore recommended to use mounting profi les according to the rule:
AQUALUC
length in cm < mounting profile length in one piece
. Failure to observe this rule will inevita-
bly compress or stretch the LED light line and void the warranty.
If you use
adhesive tape
, please ensure that the surface to be taped is dry, even, and clean
(no fat, oil, silicone and dust particles). To achieve best adhesion, the surface of the AQUALUC
C:URVE mini should also be clean (if necessary clean the surface of the LED light line with
a soft, slightly damp cloth. To remove more severe stains use a standard cleansing material
without
abrasive elements).
Fix the tape on the bottom side of the AQUALUC C:URVE mini or on the mounting surface
and press the LED light line firmly. The contact pressure should not exceed 10-15 N/cm
2
,
otherwise the LEDs or the electronic parts of the AQUALUC C:URVE mini could be damaged.
If you select the
construction adhesive
then it is important to ensure an even and slight wave
form distribution. The amount of adhesive used should be relative to the size of the required
adhesive surface.
ILLUSTRATION 1:
PLEASE NOTE BEFORE INSTALLATION
The product should always be installed by two people in order to avoid a sagging of the
LED light line.
