Bartell Morrison Inc.
375 Annagem Blvd., Mississauga, ON, Canada
Toll Free - 866-501-1683
Bartell Morrison (USA) LLC
12 Industrial Dr., Mississauga, NJ, USA
Toll Free - 888-999-1570
5
Safety Hazard
alert:
Alerts the reader to
personal injury hazards
and other important,
potentially life-saving
information.
daNGer:
Beware of a hazardous
situation that WILL re
-
sult in serious personal
injury or death.
WarNING:
Beware of a hazardous
situation that COULD
result in serious per-
sonal
injury or even death.
CaUtION:
Beware of a hazardous
situation that could
result in minor personal
injury or equipment
damage.
PRODUCT SAFETY AND HAZARD ALERT SYSTEM
This Operating Manual presents Product Safety and Hazard Alert Information in accordance with
American National Standards Institute
and
International Organization for Standardization
rec-
ommendations as laid out in
ANSI Z535
and
ISO 3864.
The callouts of
DANGER, WARNING,
CAUTION
, and
NOTE
must be followed to reduce or avoid the potential for personal injury,
equipment damage, or service-related equipment failures.
Only persons who have received training are permitted to operate or repair the grinder.
1.
Use personal safety equipment such as steel toe shoes, safety glasses, gloves and ear
2.
plugs.
Do not use grinder in area where there is a risk of explosion or fire.
3.
Do not start the machine with heads off the ground.
4.
Make sure the splash guard is on before starting machine.
5.
Before you start grinding, check the floor for bolts, large holes and uneven joints. Hitting
6.
these things can damage machine, tools, and cause personal injury.
Make sure all power supply is connected with the right voltage.
7.
Use only cold water in water tank. Do not use chemicals in water tank.
8.
When filling water tank, to avoid electrical hazards and injury, do not spill water onto the
9.
machine motor and electrical box.
Switch off the machine power before changing grinding tools.
10.
Disconnect power supply before working on or repairing machine.
11.
Be very careful with rolling machine on any sloping floors or ramps. The machine can roll
12.
very quickly. Two people may be needed to handle and control the machine.
Use caution when removing the grinding tools after finished grinding. Tools can be very
13.
hot. Use gloves to remove the plates.
When grinding glues, epoxy paints, or coatings, leaving the machine down on floor could
14.
cause the head to stick to the floor. Always tip back machine as soon as the head comes to
a complete stop.
Always store machine in a dry place.
15.
Only use Innovatech recommended tooling.
16.
