BSM1402 MASONRY SAW
OI
– B19042
OWNER
’S MANUAL
10
ASSEMBLY AND OPERATION
Blade Installation
1.
Open the blade nut door found on the blade guard by rotating it. Using the supplied wrench,
loosen the nut.
2.
Remove the nut and the outer flange.
3.
Install a new blade. Make sure the blade rotation
arrow coincides with the rotation direction of the
blade shaft.
4.
Reattach the outer flange and blade nut.
5.
Using the same wrench tighten the blade nut and
close the blade nut door.
Water Pump Installation
1.
Hang the optional water bucket on the hook found at the rear center of the saw frame.
2.
Place the water pump inside the water bucket (figure 4).
3. If no water bucket is available, place the water pump inside the water tray behind the splash
guard (figure 5).
WARNING:
Disconnect the pump before attempting to handle the pump.
Never operate pump without water in the tray.
figure 4
figure 5
figure 3
