Barcode Hand Scanner
BCS 160
ex
Series, Types 17-21BA-M31S/…….. and 17-21BA-M32S/……..
Commissioning
Technical data subject to change without notice.
Revision A / Status: 01/2014
23/48
5.2
Requirements in Hazardous Areas
Hand Scanner
1.
The hand scanner must not be opened.
2.
Do not use, swap for or replace any non-specified components.
3.
Do not retrofit any components on the internal plug connectors or slots.
4.
Protect the hand scanner from the effects of impacts!
5.
Do not expose the hand scanner to any caustic/aggressive liquids, vapours, mists!
6.
Avoid the impacts of moisture outside the specified range.
7.
Avoid thermal impacts outside the specified temperature range.
8.
Use the external contacts only with the devices specified by the manufacturer!
Battery
1.
The battery must not be opened.
2.
Take the device out of the hazardous area before changing the battery.
3.
In the hazardous area use only the accessories specified by BARTEC to charge the
battery.
Ex base station (type 17-21BB-1707/0000)
4.
Use the battery only for the purpose specified in this User Manual. It is only suitable
for use in the BCS 160
ex
BT hand scanner (type 17-21BA-M32S/…….).
5.
If not used properly, there is a risk of burns.
6.
Do not expose the battery to any temperatures higher than +60 °C (140 °F).
7.
In the event of damage, it is possible for battery acid to leak from the cells and cause
acid burns.
8.
Defective batteries must be disposed of immediately, whereby the battery disposal
regulations that apply in the respective region must be observed.
9.
The battery can explode if it catches fire!
10.
Do not short-circuit the batteries!
Accessories
1.
Accessories that were not explicitly approved for use in the hazardous area must be
installed or replaced only outside the hazardous area.
2.
Use only accessories which have been tested or certified by BARTEC for this
purpose.
Summary of Contents for 17-21BA-M31S Series
Page 2: ......
Page 6: ...Blank...
