Bartec 17-21BA-M31S Series, User Manual

Page: 45 / 56

Barcode Hand Scanner
BCS 160
ex
Series, Type 17-21BA-M31S/…….. and 17-21BA-M32S/……..
Operation
Technical data subject to change without notice.
Revision A / Status: 01/2014
39/48
Base station
Contacts
To clean the contacts, take the battery out of the device and close
the battery compartment.
−
Dip the cleaning cotton buds in alcohol solution and then use
them to remove every deposit of grease and dirt on the contacts.
−
Repeat cleaning several times.
Make sure the contacts are completely dry and there is no fluff left
sticking to them before you put the device back onto the cradle.
Charging
Station
Plug
connectors
Before you start to clean the charging station contacts, disconnect
the charging station from the power supply.
− Dip the cleaning cotton buds into the alcohol solution and then
use them to remove every deposit of grease and dirt on the
contacts.
− Repeat cleaning several times.
Make sure the contacts are completely dry and there is no fluff left
sticking to them before you reconnect the charging station to the
power supply.
Cable
Connectors
Before you start to clean the cable connectors, disconnect the hand
scanner from the power supply.
−
Dip the cleaning cotton buds into the alcohol solution and then
use them to remove every deposit of grease and dirt on the
contacts.
−
Repeat cleaning several times.
Make sure the cable connectors are completely dry and there is no
fluff left sticking to them before you reconnect the cable connectors
to the power supply.
6.4 Operation, Recommendations and Requirements
6.4.1 Basic Safety and Health Protection Requirements
Please consult your local health and safety officer to ensure that you are familiar with the
safety regulations your company has put in place in order to protect employees in the
workplace.