Barrus ShireZ Electric 6HP, Operator'S Manual

Page: 21 / 97

RDG603A74 - Issue 4 Page 21 of 97
•
Refit the coolant cap to the outboard motor, making sure it is fully tightened.
*Note : The S06 takes approximately 1.75 litres of antifreeze-water mix to fill, whereas the
approximate amounts for the S10 and S20 are 2 and 2.1 litres respectively.
3. Adjusting the Outboard Motor Transom Height
*Note : The outboard has an adjustable transom height system, there are a number of
positions to choose from between short and long shaft.
•
Prior to fitting the outboard motor make sure the correct transom height is chosen for
the hull of the vessel. (see 4. Mounting of the Outboard Motor).
•
To adjust the transom height, remove the bolt on the shaft (see Figure 13 ). Select the
correct hole on the shaft which will give you the correct transom position. Refit the bolt
and tighten the nut and bolts securely.
Figure 13: Adjusting the transom height
Adjustment holes
Bolt to remove