Barranca Diamond BD10, Owner'S Manual And Operating Instructions

Page: 13 / 36

13
Fig. 5. Secure sludge plug
START UP
Inspect the belt tension. Check the four motor mounting bolts (Fig. 6) to ensure they are tight and the motor
is secure. The V-belt is adjusted and tensioned at the factory. If belt needs adjustment, loosen nut (Fig. 8).
Tighten or loosen screw (Fig. 9) until belt is properly tensioned. There should be no more than 1/2" of belt
deflection when the belt is depressed by fingertip pressure (Fig. 7).
Fig. 6. Motor mounts bolts
Fig. 9. Adjust screw
Fig. 10. Loosen clutch plate Fig. 11. Rock vise
Fig. 7. V-belt correctly tensioned Fig. 8. Loosen nut
To perform a power up test on the BD10, first disengage the vise clutch by turning the knob counterclockwise
to loosen the clutch plate (Fig. 10). Move the vise to the front (operator's) end of the saw table (Fig. 11).
START UP
When you have confirmed that the belt is properly tensioned and the motor mounting bolts are secured. You
are ready to proceed. Be sure the proper amount of lubricant is in the reservoir. Check to ensure that the toggle
power switch is in the MIDDLE/OFF position.
BD10 OPERATIONS AND ADJUSTMENTS