16
Fig. 22. Manual feed position
Fig. 23. Loosen vise
Fig. 24. Rotate vise up
TRIM SAWING MODE
Slabbing of rock material to uniform thicknesses using the BD10 Trim Saw is best performed using the auto-
matic power feed mode. However, manual trimming of slabs to desired shapes (preforming) can be achieved
using the saw in the LEFT/MANUAL FEED position (Fig. 22).
To use this mode, first place the toggle in the MIDDLE/OFF position (Fig. 9) and flip the vise assembly over the
cross feed rail by removing the knob on hinged portion of the vise (Fig. 23) and rotating the vise so that it pivots
off the saw table (Fig. 24). At this point the saw is ready to be used in the manual mode (with only the blade
motor activated) for manual trimming of slabs by placing the toggle in the LEFT/MANUAL FEED position.
BD10
OPERATIONS AND ADJUSTMENTS
Summary of Contents for BD10
