Baroness SP05, Service Manual

Page: 77 / 142

Hydraulic oil filter
Change of hydraulic oil filter
Contamination of the hydraulic oil causes a
failure of the hydraulic equipment. Change the
hydraulic oil filter regularly.
Change period
First time
After 100 hours of
operation
From the
second
time
onward
For every 500
hours of operation
Remove old cartridge filter (2).
Apply clean hydraulic oil onto the packing
of new filter for replacement.
Screw in the filter by hand till the packing
touches the fitting surface. Then, further
tighten for 1/2 turn.
After fitting, start the engine to warm up the
oil. Then, stop the engine and check for the
leakage of oil.
1
2
ycfdh6-002
Change of hydraulic oil filter_001
1 Fuel tank
2 Cartridge filter
Removal and installation of each
section
Raise/lower cylinder
Removal of raise/lower cylinder
Lower the rake part.
Remove the hydraulic hoses (2) fitted to the
raise/lower cylinder (1).
Remove the split pin (4), snap pin (5) and
washers (6), then remove the hardened flat
head pins (3).
Remove the raise/lower cylinder (1).
1.
2.
3.
4.
1.
2.
3.
4.
4
6
5
6
2
1
3
5hgpfu-001
Removal of raise/lower cylinder_001
1 Raise/lower cylinder
2 Hydraulic hose
3 Hardened flat head pin
4 Split pin
5 Snap pin
6 Washer
Fitting of raise/lower cylinder
For fitting, follow the opposite procedure of
removal.
Caution
After fitting, check for hydraulic oil leakage at
each part.
Refer to the tightening torque list. We assume
no responsibility for problems caused by
abnormal tightening, tightening with excessive
torque or the like of.
Drive switching valve
Removal of drive switching valve
Remove the hydraulic hose (1) fitted to the
drive switching valve (6).
Remove the elbow (2) and the adapter (3).
Remove the bolt (4).
Remove the drive switching valve (6)
together with the sub-plate (5). 1.
2.
3.
4.
Hydraulic system
Hydraulic system
Page 5-39 Removal and installation of each section