Move
Traveling Procedure
Warning
Set the reel rotation switch to the "Stop"
position except during mowing or backlapping
and using reel excess discharge system.
Caution
Under any circumstances drive the machine at
such a speed that you can stop it immediately
for emergencies.
Caution
In case of 2WD/3WD model, travel in 2WD
mode since it is dangerous to travel on steep
downward slopes, wet road surface or
downward slopes of wet lawn in 3WD mode.
Rear tire going into a skid may cause loss of
traveling control.
Important
Do NOT start to move or stop the machine
abruptly.
It will damage the hydraulic system or result in
oil leakage.
Start the engine.
"Procedure to Start Engine" (Page 5-13)
Gradually move the throttle lever to the "High
speed" position.
Raise all mower units.
While pressing the push button, lower the
parking brake lever.
Slowly depress the traveling pedal.
The machine starts traveling.
The machine stops slowly when the traveling
pedal released.
1.
2.
3.
4.
5.
6.
7.
Cutting Work
Cutting Work
Caution
Cutting work must be performed at an
appropriate speed for the site and location.
When mowing over bumpy surfaces, keep the
engine rpm steady, and slow down the cutting
speed.
Caution
In case of 2WD/3WD model, travel in 2WD
mode since it is dangerous to travel on steep
downward slopes, wet road surface or
downward slopes of wet lawn in 3WD mode.
Rear tire going into a skid may cause loss of
traveling control.
Caution
Be sure to install the grass catchers.
Otherwise, flying objects from the mower units
may hit your feet.
Important
Do NOT start to move or stop the machine
abruptly.
It will damage the hydraulic system or result in
oil leakage.
Install the grass catchers.
Shift all the reel rotation/stop switching lever
to "Rotation" position.
Shift all the groomer clutch lever to
"Rotation" position.
Start the engine.
"Procedure to Start Engine" (Page 5-13)
Raise all mower units.
While pressing the push button, lower the
parking brake lever.
Shift the throttle lever to the "High speed"
position to run the engine at the maximum
speed.
Set the reel rotation switch to the "Rotation"
position.
Start the work following the procedure below.
Depress the traveling pedal.
1.
2.
3.
4.
5.
6.
7.
8.
9.
[1]
Handling Instructions
LM311
Handling Instructions
Page 5-15
Move
