1
Ignition key
A
OFF
B
ON
C
GLOW
D
START
Make sure that the glow plug is generating
heat and the thermo-start lamp is turned on.
1
2
3
v2e27i-011
Procedure to Start Engine_003
1
Charge lamp
2
Thermo-start lamp
3
Oil pressure lamp
Important
Quickly returning the ignition key from the
"START" position to the "ON" position may
damage the machine.
After the thermo-start lamp turned off,
immediately set the ignition key to the
"START" position.
When the starter starts rotating and the
engine starts, slowly return the ignition key to
the "ON" position.
Check that the charge lamp and the engine
oil pressure lamp turn off.
When they do not turn off, stop the engine
and inspect the machine.
8.
9.
10.
11.
Shift the throttle lever to the "Low speed"
position, warm up the engine so that the
needle points above "C" on the water
temperature gauge.
1
igozke-001
Procedure to Start Engine_004
1
Water temperature gauge
Procedure to Stop Engine
Set the traveling pedal to the neutral
position.
Apply the parking brake.
Set the reel rotation switch to the "Stop"
position.
Shift the throttle lever to the "Low speed"
position, and warm up the engine for 1-2
minutes.
Lower all the mower units completely.
Switch the ignition key to the "OFF" position.
Check the engine has stopped.
Parking and Stopping
Leaving The Machine
Caution
If the brakes are not sufficiently effective, use
the wheel stoppers to secure the machine.
Caution
Never park the machine on a slope.
Park the machine on level ground.
Apply the parking brake.
Stop the engine.
Remove the ignition key.
Step off the machine.
Close the fuel cock.
12.
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
4.
5.
6.
LM311
Handling Instructions
Page 5-14
Parking and Stopping
