Baroness LM283, Owner'S Operating Manual

Page: 54 / 75

Open the unload valve located on the rear
frame.
1
gay3t1-002
Towing the Machine_002
1 Unload valve
Important
Before towing, be sure to open the unload
valves in two locations.
While pressing the push button, release the
parking brake lever and remove the wheel
stopper.
Tow the machine slowly.
Opening and Closing the Unload Valve
Caution
Unless you plan to tow the machine, tighten
the needle valve of the unload valve securely
and tighten the lock nut firmly.
Important
Do not rotate the needle valve of the unload
valve more than once.
Loosen the lock nut.
Loosen the needle valve (located in the
center) to open the unload valve.
B
A
2
1
mxqgsb-001
Opening and Closing the Unload Valve_001
4.
5.
6.
1.
2.
1 Needle valve
2 Lock nut
A Tighten
B Loosen
Cutting Work
Cutting Operation
Warning
Do NOT start to move or stop the machine
abruptly.
To do so is very dangerous. In addition, it may
damage the hydraulic system or result in oil
leakage.
Caution
Cutting work must be performed at an
appropriate speed for the site and location.
When cutting bumpy surfaces, keep the
engine rpm steady, and slow down the cutting
speed.
Caution
Reel rotation will be turned on or off based on
the sensor-detected position of the mower
units.
Please note that if you stop operating the
mower unit up/down lever before the mower
units are raised completely, reel rotation may
not stop.
Start the engine. (See "Procedure to Start
Engine" (Page 4-20) .)
Raise all mower units, and set the anti-falling
stop valve to the "Stop" position.
Depress the brake pedal, and while pressing
the push button, return the parking brake
lever to its resting position.
Shift the throttle lever to "High", and rev up
the engine to MAX (3,100 rpm).
Right before starting cutting work, set the
anti-falling stop valve to the "Open" position.
Shift the mower unit up/down lever to the
"DOWN" position to lower the mower units.
Shift the reel rotation lever to "FORWARD"
to rotate the reel cutters (cutting cylinders)
for all mower units in cutting (positive)
motion. 1.
2.
3.
4.
5.
6.
7.
LM283
Handling Instructions
Page 4-32 Cutting Work