Baroness LM283, Owner'S Operating Manual

Page: 52 / 75

Thermo-start Lamp
The thermo-start lamp is the middle pilot lamp
located in the operation panel.
When the ignition key is set to the "GLOW"
position, it illuminates as the glow plug
generates heat.
Illumination of the thermo-start lamp is
controlled by the glow lamp timer, and the
lamp is turned off after a specified amount of
time passes.
The duration of illumination indicates an
approximate period of time required for warm-
up, and has been fixed at five seconds.
1
࠴ࡖ࡯ࠫ ࠨ࡯ࡕࠬ࠲࡯࠻ ࠛࡦࠫࡦᴤ࿶
q44uug-001
Thermo-start Lamp_001
1 Thermo-start lamp
Oil Pressure Lamp
The oil pressure lamp is the right pilot lamp
located in the operation panel.
It turns on when the ignition key is set to the
"ON" position before the engine starts. It turns
off when the engine starts and engine oil
pressure is generated properly.
If this lamp illuminates while you are operating
the machine, stop the engine immediately,
and then inspect the machine and perform
any necessary maintenance.
1
࠴ࡖ࡯ࠫ ࠨ࡯ࡕࠬ࠲࡯࠻ ࠛࡦࠫࡦᴤ࿶
1ldikn-001
Oil Pressure Lamp_001
1 Oil pressure lamp
Overheat Warning Buzzer
If the water temperature inside the engine
exceeds 105 degrees Celsius, a buzzer will
sound. (intermittent tone)
Remove the load from the engine, idle the
machine for five minutes, stop the engine, and
then inspect the machine and perform any
necessary maintenance.
Angle Meter
The angle meter is located in the operation
panel.
This instrument indicates the angle of the
machine position.
1
al3bhj-001
Angle Meter_001
1 Angle meter
LM283
Handling Instructions
Page 4-30 Instruments