Baroness LM281, Owner'S Operating Manual

Page: 62 / 92

Cutting Work
Cutting Operation
Warning
Do NOT start to move or stop the machine
abruptly.
To do so is very dangerous. In addition, it may
damage the hydraulic system or result in oil
leakage.
Caution
Cutting work must be performed at an
appropriate speed for the site and location.
When cutting bumpy surfaces, keep the
engine rpm steady, and slow down the cutting
speed.
Caution
Please note that if you stop operating the
mower unit up/down lever before the mower
units are raised completely, reel rotation may
not stop.
Reel rotation will be turned on or off based on
the sensor-detected position of the mower
units.
Caution
Stop the engine before installing or removing
the grass catcher.
Shift the reel rotation/stop switching levers of
all mower units to the "Rotate" position.
Start the engine.
"Procedure to Start Engine" (Page 4-18)
Raise all mower units, and set the anti-falling
stop valve to the "Stop" position.
Depress the brake pedal, and while pressing
the push button, return the parking brake
lever to its resting position.
Increase the engine speed to the maximum
rpm by moving the throttle lever toward the
high-speed position.
Right before starting cutting work, set the
anti-falling stop valve to the "Open" position.
Shift the mower unit up/down lever to the
"DOWN" position to lower the mower units. 1.
2.
3.
4.
5.
6.
7.
Shift the reel rotation lever to "FORWARD"
to rotate the reel cutters (cutting cylinders)
for all mower units in cutting motion.
Depress the traveling pedal to start cutting
work.
Note:
During the work, the reel cutters (cutting
cylinders) will rotate or stop in sync with the up
and down motion of the mower units.
Transporting
Transporting Procedure
When loading this machine into a trailer or a
truck to transport it, drive the machine in
reverse. When unloading, drive the machine
forward.
If the roof is installed on the machine, remove
it.
The roof may be damaged by wind pressure.
Storage
Before Long-Term Storage
Remove dirt, grass clippings, debris, oil
stains etc. completely.
Supply oil and apply grease to appropriate
parts.
Remove the negative terminal of the battery.
8.
9.
･
･
･
LM281
Handling Instructions
Page 4-32
Cutting Work