12
Installing the Control Panel in a
Remote Location (See Fig. 1)
For your convenience, the control panel can be removed
from the unit and mounted at a convenient location within
10 ft. (3.1 m.) of the unit. To remove the control panel
from the unit:
1.
Turn the unit OFF and disconnect it from the
power supply.
2.
Slide the control panel upward about 1/4” (0.64
cm) to 3/8” (0.95 cm) - (just enough to clear
connector on top cover), pull forward, and
remove. (The control panel fits tightly in the unit
so it may be difficult to remove.)
3.
Replace the control panel with the blank panel
provided with the unit to protect the electrical
connector.
4.
Using the display wall bracket as a template,
locate and drill the mounting holes in the wall. A
minimum of two (customer-supplied) fasteners
will be required. Attach the wall bracket to the
wall using the customer-supplied fasteners.
5.
Locate the 25-pin connector on the left side of
the unit. Remove the protective cover and store
it for future use if the control panel is returned to
the top cover.
6.
Locate the 10 ft. (3.1 m.) 25 pin M-F cable
included with the unit; attach the male end to
the 25 pin connector on the left side of the unit,
and the other end to the connector on the bot-
tom of the control panel.
7.
Tighten the cable screws on each end to secure
the cable to the unit and control panel.
8.
The control panel may now be mounted on the
wall.
9.
An accessory bench mounting display bracket
(AY1367X2) can be used. Contact Barnstead
International to order.
I
NSTALLATION
Note
The removable control panel was not
designed to be repeatedly removed
from the unit, therefore, you may
experience difficulty when attempting
to remove it. It is therefore
recommended that the control panel
be permanently mounted in a remote
location or remain intact with the unit.
Caution
Repeated removal and replacement of
the control panel from the top cover
may eventually cause it to become
damaged.
Note
The protective cover on the rear side
panel display connector should remain
in place when the display is not
remotely located.
Blank panel
Control Panel Wall Mount Bracket
Figure 1: Mounting the
Control Panel
Note
A bracket is available that will allow
you to mount the control panel on the
bench. If bench mounting is desired,
please order bracket AY1367X2.
Control Panel Mounted in Remote Location
