17
2.
Wet the o-rings on both end caps
of the prefilter.
3.
Insert the upper end cap into upper
center position until it bottoms out
in the connector. (The upper end
cap is the one with the right angle
turn and the two flanges.) The two
flanges on the end cap slide down
on each side of the keyway wall.
(See Figure 7.)
4.
Lower the prefilter and insert the
lower end cap into the lower center
socket until it is firmly seated.
Membrane Installation
1.
Remove the membrane bypass
tubing from the EASYpure RO (see
Figure 5). The membrane bypass
tubing may be stored inside the
EASYpure RO case for easy
access when needed for the sys-
tem sanitization procedure.
I
NSTALLATION
Figure 5 Membrane Bypass Tubing Installed
Membrane By-Pass Tubing
Note
The membrane by-pass tubing will
be needed for sanitizing the
EASYpure RO. Do not discard it.
