7
1/8" NPT x 1/4" OD straight connector
provided to connect the Bantam Holder
inlet to the raw water supply. If the raw
water supply service connection is not
3/8" NPT, use another brass fitting as
required.
3.
Cut a piece of tubing from the 2.1m (7')
of 1/4" OD tubing (part no. TU1494X1)
provided to make the plumbing service
connection between the raw water faucet
and the plumbing service connection
marked “inlet” on the Bantam Holder.
Ensure that sufficient tubing is left to
drain the holder through the plumbing
service connection marked “drain” on the
Bantam Holder to the sink and to make
the plumbing service connection
between the holder effluent connection
at the top of the unit and the point of
distribution.
4.
Thread the 1/8" NPT x 1/4" OD straight
connector provided (part no. 15451) into
the brass bushing at the faucet opening
and connect the tubing between this
connection and the plumbing service
connection marked “inlet” on the holder.
5.
Ensure that the 1/8" NPT x 1/4" OD
polypropylene elbow (part no. 15847) is
threaded into the effluent connection at
the top of the holder and connect tubing
between this connection and the point of
distribution. See
Elbow-Tubing Assembly
in this manual to ensure that the
connection is made properly to prevent
leakage.
I
NSTALLATION
Summary of Contents for 494 Series
Page 12: ...12 Exploded View...
Page 15: ...15...
