Anchoring the pavilion
BAR LOW T Y R IE
quality since 1920
www.teak.com
Page11 of 16
Top View
3-1/4” (8.2cm)
Permo
®
Lock Anchoring System
Insert the assembled
Permo Lock anchor
into the drilled hole
Unscrew the coupling
and rod completley
from the fixed Permo
Lock anchor and
remove the two
washers
Place the corner of the structure
over the anchor and afix it using
the supplied ½” bolt and washers.
Grease the threads of the bolt
Screw in the coupling nut without
turning the rod and anchor.
The maximum opening of the
Permo Lock anchor occurs when
the rod extends 3¾” (8.2cm)
above the coupling nut
Drill a 1” x 19¾” (2.5cm x 50cm)
hole at each marked location
using a percussion drill with a
diamond tip masonry drill bit
Apply grease on threads
19¾”
(50cm)
x4
lock washer
x4
washer
x1
rod
x4
bolt
x1
coupling
x4
anchor
Position your assembled
structure on the chosen
location then mark the
center of each corner plate
Packaging Contents
One Permo Lock anchor comes
preassembled and ready to use
as shown on the right. Verify that
the rod end is flush with the end
of the anchor.