Service work
Barkey GmbH & Co. KG - Gewerbestrasse 8 - 33818 Leopoldshoehe – Germany - Head Office: +49 (5202) 9801-0
23
Customer Service: +49 (5202) 9801-30 Fax: +49 (5202) 9801-99 - e-mail: [email protected]
Service manual
Barkey warming center III DTM
Refitting:
Refitting the heater insert takes place in reverse order to removal:
►
Connect the earthing cable to the spade connector (on the cover).
►
Place the cover plate on the heater insert and fix it with the six countersunk screws.
WARNING
Ensure that the earthing cable is not crushed.
►
Place the heater insert on the guide rails and push it halfway into the heating cham-
ber.
NOTE
You must push uniformly and in a straight line towards the rear, otherwise the
heater insert will jam.
►
Plug the low-heat device plug into the heater insert.
►
Now you can push the heater insert in completely.
WARNING
Ensure that the low-heat device cable is behind the air deflector and is not being
crushed.
►
Fix the heater insert with the two screws after fitting washers.
Summary of Contents for warming center III DTM
Page 2: ......
