Manual 2100-635A
Page
9 of 18
10. Remove female plug of high voltage wiring harness
(3-pin plug) from the heat recovery assembly
and snap into the unit control panel (from inside
control panel) in the hole provided. Wire to top
of compressor contactor per wiring diagram (see
Figure 6 on page 9). Connect high voltage plugs
back together (see Figure 5).
MIS-3747
VENTILATOR
SIDE SECTION VIEW
GRILL AND SERVICE DOOR
BETWEEN THE CONDENSER
PARTITION
SERVICE DOOR
CONDENSER
LIP OF ERV IS TO BE
HEAT RECOVERY
FRONT GRILLE
GRILLE TO INSERT A SELF DRILLING
SCREW
CENTERED OVER HOLE IN CONDENSER
SO THAT HOLE IN FROM LIP IS
WHEN INSTALLING WERV POSITION
HIGH & LOW VOLTAGE
TO PLUG IN SIDE OF
CONTROL PANEL
CAUTION: HOLE IN WERV MUST
BE USED TO INSURE CLEARANCE
FROM CONDENSER COIL TUBING
MIS-3747
FIGURE 5
Plug Exhaust Blower Into Control Panel
FIGURE 5 (INSET)
