Bard Q-TEC Q A4D Series, Installation Instructions Manual

Page: 30 / 97

Manual 2100-752C
Page 6 of 41
Hold Skid
Down
A Shipping Brackets B Front Wheels Over Edge
C Front Wheels On Floor
FIGURE 2
Removal of Q-TEC Unit from Skid
MIS-1007
Unit Removal from Skid
It is not recommended that the unit be removed from
the skid with a fork lift as the air seal under the unit
could be damaged (see Figure 1).
The shipping brackets on each side of the unit must be
removed and discarded (see Figure 2). The return air
grille panel can be removed to provide a place to hold
the unit.
FIGURE 1
Air Seal Under Q-TEC Unit
Air Seal
MIS-1008
The unit can be tipped forward and slid down the edge
of the skid until the front wheels touch the ground. The
wheels will not roll as they are shipped from the factory
locked. The back of the skid will have to be held down
to keep it from tipping up. The skid can be slid out
from under the unit. The unit can then be set upright.