Manual 2100-549Q
Page
20 of 69
D
REF.
A AND B
REF.
(4) 5/16" - 1/2" NON-TAPPING
REF.
E
REF.
(6) 5/16" - 3/4" NON-TAPPING
C
(4) 1-1/2" LONG SCREWS
REF.
E
(18) 5/16" - 3/4" SELF TAPPING
B
C
REF.
REF.
REF.
A
REF.
D
MIS-3014 A
Use (4) 1-1/2" Long
Louver Grille to
Outer Sleeve.
Screws to Attach
to Outer Sleeve
to Attach Inner Sleeve
Self Tapping Screws
Use (6) 3/4" Long
Unit Fan Shroud
Exhaust Sleeve to
Screws to Attach
Use (6) 3/4" Long
Use (12) 3/4" Long
to Attach Inner Sleeve
to Unit Back
Self Tapping Screws
Use (4) 1/2" Long
Screws to Attach
frame to Exhaust
Sleeve
Use (12) Field Supplied Concrete
or Wood Screws to Secure Outer
Sleeve to Structure.
outer sleeve.
IMPORTANT!
IMPORTANT!
between inner and
entire perimeter seam
seal between unit and sleeve.
IMPORTANT!
Doing so may compromise water
to not damage gasketing material.
Use care when inserting screws
Apply Caulk bead to
Apply liberal amount
of caulk to back of
flange before installing.
Pull Inner Frame
Out Until Flush
With Grille Mounting
Angle
5. Unplug heat recovery cassette on the side chosen to
access, and slide cassette out the front of the unit.
6. Remove two (2) screws securing partition on
outboard side of cassette and remove.
7. Rear drain access panels are now visible on both
right-hand and left-hand sides in rear of box.
FIGURE 11A
Unit Mounting
