Manual 2100-614I
Page
16 of 43
If Network Uses Static IP Addressing
1. Enter the correct address information provided
by the IT department and click the “Save Config”
button.
2. The assumption is that the new IP address has
already been configured into the network to get
through any firewall(s).
3. Disconnect the Ethernet cable from the computer
and plug into the router.
4. Change the computer system’s IP address back to
their previous settings recorded in
NOTE 1
.
5. Type the new IP address into the browser and make
any changes to the MC4000 system before logging
out.
If Network Uses DHCP
1. Check the “Enable DHCP” box.
2. Click “Save Config” box. It will take several
seconds before receiving a message that it is now
offline. At this point the unit is now running in
DHCP mode.
3. Change the computer system’s IP address back to
their previous settings from
NOTE 1
.
4. Type CB5000 in the browser’s URL address bar to
access the CB5000.
NOTE 2:
To get back to the CB5000 default IP setting,
simply hold the reset button next to the Ethernet jack
for 5+ seconds, then release.
Connect to Network
1. After initial set up using laptop computer,
disconnect computer cable from the Ethernet port
and connect the CAT 5 or CAT 6 network cable.
2. Remote access is now available using the assigned
IP address and valid user name and password (case
sensitive).
Setpoints Page
NOTE:
“Read” level authority can view this screen
but cannot make any changes. “Admin” and “Write”
authority can make changes.
1. General Setpoints
a. On initial installation and start up, all
selectable characteristics are set to factory
default settings.
b. Each of these points has a drop-down menu for
ease of use.
2. Alarm Board Setpoints
a. Low temperature alarm setpoint
b. High temperature alarm #1 setpoint
c. High temperature alarm #2 setpoint
3. System Overrides
a. System 1 Cooling Override
b. System 1 Heating Override
c. System 2 Cooling Override
d. System 2 Heating Override
e. Turn Power On to the System (
NOTE: Cannot
remotely turn the controller system Off
)
f. Lock/Unlock Controller
g. Advance Lead to Lag Unit
MC4000 HVAC Monitor / Controller
