~ 15 ~
photos from the Micro SD card and try to print them.
(2)Some DPOF compatible printers and digital photo developing shops may fail to print the photos based on
the specific settings. If this is the case with your printer, please refer to the User Manual attached to it. In
another case, please check the DPOF compatibility with the digital photo developing shop.
(3)lf the DPOF information of the Micro SD card has been set by another camera, please do not insert this card
into FOOLISH to reset the DPOF information, or the DPOF information may be invalid or covered. Sometimes,
special photo types make it impossible to set the DPOF information.
7.
Remote control
You can use the attached remote control of FOOLISH to control the video recording, photo shooting, stopping
and laser function turning on/off. The red indicator on the remote control will twinkle once when you press any
of the following keys:
Please follow the steps below to code the remote control before use to realize the correspondence of remote
control and FOOLISH :
1.
Turn off FOOLISH , press and hold "Record" key, turn the power switch to "ON", and then release "Record"
key. To conclude the process of synchronization (hold "Record" of FOOLISH) press the "Stop" and "Record"
button once for 3 seconds. After successfully synchronized the remote control, you will hear a double beep.
Note:
a.
Use wireless remote control to control FOOLISH can check whether the code pairing is successful. The
control functions include: Video recording starting/stopping, photo shooting, waking in standby mode,
and laser light turning on/off; FOOLISH will tick once for each operation. In case of video recording
stopping or laser light turning off, FOOLISH will tick twice;
b.
Remote control range: Remote control within 1 5 meters in anyangle horizontally without barriers
c.
To press "Record", "Shutter" or "Stop" key on the remote control in standby mode can wake up the system
8.
Standby mode:
A.
Non-voice control standby:
Push the VOX switch to "OFF" and turn the power switch to "ON", the system will start working and it will enter
preview state after finishing initialization. In case of no any mission and operation, the system will auto enter
standby power-saving mode at the end of the auto standby time set. Press "Record" or "Shutter" key at this
time, or remote control any key on the remote control, the system will be waked up.
Note:
a To press keys on TFT screen in standby mode cannot wake up the system;
long press "Shutter" key for 3 s can
turn on and turn off the laser
function
Record
Shutter-Stop
Pausa
