Barco XDM, Installation Manual

Page: 59 / 104

59 R5914477 /00 XDM
Image 4 – 20 Example of all three mounting positions of the optical adapter on a B-lens.
5. Drive in the three hex screws into the screw inserts. Use a torque wrench with hex bit to tighten the screws
with a gentle force of 0.1 Nm. Fasten the three screws alternately and evenly.
Tip: Use the M3 screws with ring 1, use the M4 screws with ring 2.
Caution: Only a force of 0.1 Nm is necessary. Driving in the screws with too much force may end
up breaking the plastic ring instead.
6. Test if the lens adapter is held tightly enough onto the lens. Use gentle force to try to remove it. If you
cannot remove the adapter this way, the adapter is mounted correctly. However, if you can remove the
adapter this way, retry this procedure.
Note: Use gentle force. If you use brute force, the adapter WILL come lose and be removed.
This is normal behavior.
Keep the packaging of the optical adapter aside. If you remove the lens, it is advised to keep the
optical adapter in its original packaging to prevent it from getting damaged.
How to install a lens into the B-lens holder, while using the optical adapter
1. Place the lens holder in the “ unlocked ” position. Do this by pulling the lens lock handle (reference 1,
Image 4 – 11 ) outward and then towards the lens power supply socket (reference 2) as illustrated.
1
2
Image 4 – 21 Lens installation, preparing the lens holder
2. Remove the dust cover from the lens opening.
Installation procedures