5. Input & Communication
R5906113 UDX 07/07/2017
53
5.3
Installation of an input board or a communication board
W
ARNING
:
The procedures below may only be performed by Barco trained and qualified technicians.
C
AUTION
:
Always wear a wrist band which is connected to the ground while handling the electrostatic dis-
charge (ESD) sensitive parts.
Necessary tools
PH1 Phillips screwdriver
The procedure below is applicable to all the input modules of the Input & Communication Unit of the projector.
How to install
1. Switch off the projector and unplug the power cord at the projector back side.
2. Push the input module in the Input & Communication Unit using the handles. Make sure the module seats in its sliders (2).
Pull in the module until the contacts (3) are fully inserted into the connectors.
Image 5-4
3. Tighten the captive screws of the input module.
2
3
2
Summary of Contents for UDX 4K22
