Barco SLite Series, Installation Manual

Page: 36 / 41

4. Servicing
5. The person standing at the rear of the LED-wall safely disconnects the power and data cables to the tile, or if image displaying
may not be interrupted, remove the complete connection module by releasing the four bolts of the connection module (hot swap).
(image 4-5, image 4-6)
Tip: When you perform a hot swap it is recommended to place a spare connection module on the SLite tile to prevent dirt
comes inside the SLite tile. Make sure that the power and data sockets are sealed up using a power and data linking
cable.
6. The person at the rear of the LED-wall grabs the SLite tile by the rear handles and pushes the tile gently a little bit forward, out
of the LED-wall. Simultaneous, the two persons in front of the LED-wall, grab the outgoing tile at the bottom and by the side
handles. (image 4-7, image 4-8)
7. Remove the safety cable. (image 4-9, image 4-10)
Tip: The eye bolts on top of the SLite tile can be used to hook on the hook of a hoisting crane.
A
A
B
C
D
B
B
C
D
B
Image 4-5
A Lifting eye bolt.
B SLite attachment bolt.
C SLite side handle.
D SLite rear handle.
Image 4-6
Image 4-7 Image 4-8
32 R5976575 FIXED SLITE DISPLAY 17102003