Barco SLite Series, Installation Manual

Page: 33 / 41

3. Physical installation
Necessary parts
• Data Linking Cables.
• Dummy Data Plug.
Data connections
1. Connect the data cable coming from the digitizer with the ’DATA IN’ socket of the first tile. The first tile must be one of the tiles in
the corner of the SLite display (see example image 3-25).
2. Check if the correct sealing rings are present in the connector sockets of the connection module located at the back side of each
tile. Replace damaged sealing rings immediately. Use the correct sealing ring for the corresponding socket. Black colored ring
for power, red for data. (image 3-23)
3. Daisy chain the data-linking cables from the ’DATA OUT’ of one tile to the ’DATA IN’ of the next. This daisy chain linking can be
performed either in the horizontal or vertical directions starting in a corner of the SLite display.
4. Place a Dummy Data plug on the ’Data OUT’ connector of the last tile in the chain. (image 3-24)
5. Make sure that all plug holder clamps are locked firmly.
6. Specify in the setup Controlling Software how the data linking of the tiles is realized (Horizontal or Vertically) and which tile is the
first in the chain.
Image 3-23
Sealing rings.
A Red sealing ring for ’DATA IN’ and ’DATA
OUT’ sockets (
B361595 ).
B Black sealing ring for POWER IN’ and
’POWER OUT’ sockets (
B361243 ).
Image 3-24
Dummy Data Plug.
When using a Fiberlink System the fiberlink data connection is inserted between the digitizer and the first tile.
The Fiberlink Receiver is provided with a ’DATA IN’ and ’DATA OUT’ connector, just like the SLite tiles.
R5976575 FIXED SLITE DISPLAY 17102003 29