Barco SIM 7C R9011206, Service Manual

Page: 13 / 44

3. General information
3. GENERAL INFORMATION
3.1 Servicing the SIM 7C
Important remark about servicing the SIM 7C
If a SIM 7C projector fails, it will not be repaired on site, but it will be replaced by a good projector.
This is why this service manual only contains procedures to replace lamps and dust fi lters.
How to take the projector out of the system is described in the System manual .
3.2 Conventions
Projector orientation
In this manual, references to location (left, right, front, rear, top, bottom) on the projector are made as shown in the following image.
top
right front left rear
bottom
Image 3-1
Projector orientation convention
3.3 General instructions
Overview
• Connector instructions
• Wires and cable ties
• EMC shielding clamps
3.3.1 Connector instructions
C
AUTION
:
Always respect the ES (electrostatic sensitivity) instructions.
Do not use any kind of tools when unplugging a connector.
C
AUTION
:
Never pull the wires to unplug a connector. Always grip the connector and pull to unplug (after
unlocking if applicable).
Overview of the connectors
Several types of connectors are used in the projector (ordered by size):
R59770119 SIM 7C 28/05/2008 9