Barco RLM-W14, Service Manual

Page: 35 / 149

35 of 149
3-2. Troubleshooting & Error Code
Error Code Definition
In RS232 debug mode, the Main formatter board & Slave MCU will response with error code in
case of system error like lamp fail, or thermal situation failure, etc.
They are defined as below table.
Error Code Message – Troubleshooting and what parts need to replace
0
ErrMsgOverTempInlet:
–
Temp. is over spec. Check if there is anything
blocks in inlet or replace Inlet thermal sensor.
1 ErrMsgOverTempDMD
–
Temp. is over spec. Check or replace DMD thermal
sensor.
2
ErrMsgOverTempLamp1
–
Check or replace Lamp 1 thermal sensor state.
3
ErrMsgOverTempLamp2
–
Check or replace Lamp 2 thermal sensor state.
4
ErrMsgOverTempBallast1
–
Check and replace Ballast1 thermal state.
5
ErrMsgOverTempBallast2
–
Check and replace Ballast2 thermal state.
6 ErrMsgFanInitError
–
Anyone fan could be error when power on. Thus, check
and replace error fan you find out. And, try to replace fan board.
7
ErrMsgFan0RotateError
–
Fan0 gets error during projector working. Check
and replace fan 0.
8
ErrMsgFan1RotateError
–
Fan1 gets error during projector working. Check
and replace fan 1.
9 ErrMsgFan2RotateError
–
Fan2 gets error during projector working. Check
and replace fan 2.
10
ErrMsgFan3RotateError
–
Fan3 gets error during projector working. Check
and replace fan 3.
11
ErrMsgFan4RotateError
–
Fan4 gets error during projector working. Check
and replace fan 4.
12
ErrMsgFan5RotateError
–
Fan5 gets error during projector working. Check
and replace fan 5.
13 ErrMsgFan6RotateError
–
Fan6 gets error during projector working. Check
and replace fan 6.
14
ErrMsgFan7RotateError
–
Fan7 gets error during projector working. Check and