3. Replacing a bad LED from an ILite LED board
Image 3-10
2. Clean the solder paths. Do this using a solder removing wick and flux.
Note:
If a solder path is ripped of it is not possible to mount a new LED. This can happen when a LED board is physical damaged
(specially the corners).
Image 3-11
3. Place the mould and the new LED on the LED module in such a position that two pins of the new LED are accessible and the
new LED has the same orientation as all other mounted LED’s.
Caution:
Make sure that the new LED is correctly aligned with the same orientation as all other LED’s on the LED module.
Image 3-12
22
R5976460 ILITE LED REPLACEMENT KIT 29/03/2007
Summary of Contents for R9851620
