![background image](http://html1.mh-extra.com/html/barco/r9040411/r9040411_user-manual_4242996074.webp)
5. Advanced
L1 PC
L1 DVI
L3 DVI-1
L3 DVI-2
Source selection
Image 5-32
Two DVI signals detected
3. Browse to
Image > Passive to Active Stereo...
and click
Enter
.
Image 5-33
4. Click the button next to
Source 1
.
Image 5-34
5. From the list select the input connector to which the Right input signal is connected and con
fi
rm by pressing
Enter
.
Image 5-35
Note:
In case of
In
fi
tec
stereo mode, Source 1 must be linked to the Right image and Source 2 must be linked to the Left
image. This is not critical in case of
Always active
stereo mode, since the sync signal towards the emitter(s) can be
inverted through the OSD (Display setup > Stereo > Invert > On/Off).
6. Repeat step 4 and step 5 to link the Left input signal to
Source 2
.
68
R59770718 GALAXY NW SERIES 20/06/2013
Summary of Contents for R9040411
